Last Updated:
Water Immersion Rod Clean Tips The winter months have started. Now in most of the houses people have started using hot water for bathing. In most places, geysers or immersion rods are used to heat water. Using the immersion rod for a long time causes a white layer to accumulate on it, due to which it takes time for the water to heat up. In such a situation, this problem can be solved very easily.
Geysers are used in homes to heat water during cold weather, but in most places even today people use immersion rods to heat water. It is a little cheaper than geyser and electricity consumption is also less.
But after using the immersion rod to heat water for a long time, its performance gradually starts reducing. The reason behind this is the accumulation of white layer on the immersion rod. This white layer is made up of calcium and magnesium present in water.
This white layer on the immersion rod is made of calcium and magnesium, which accumulates like a crust. Due to which the rod looks dirty and apart from this it is not able to heat water effectively. After it becomes old, it has to be left on for a long time to heat the water.
Add StuffUnknownas
Preferred Source on Google
In such a situation, if you consider it bad and throw it away or you are looking for some solution to remove the white layer accumulated on it, then today we will tell you a home remedy with the help of which you can make your immersion rod shine like new.
Vinegar and baking soda can be used to remove the white layer on the immersion rod and make it shine like new. For this, fill a bucket or tub with water, add one cup of vinegar and two-three spoons of baking soda and mix well.
Dip the crusted part of the rod in this solution and leave it for some time. After about half an hour, clean it thoroughly with a brush or a scrubber and wash it with water. With this remedy, the white layer accumulated on the immersion rod will disappear and it will start shining like new.
White vinegar can also be used to shine immersion rods. For this, prepare a mixture by mixing equal amounts of white vinegar and water in a vessel. Now leave the papdi part of the immersion rod immersed in this ball for about 1 hour.
You will see that the papdi stuck on the rod will slowly start coming out on its own. Now take it out, rub it with the help of a scrubber and wash it with water. Your immersion rod will shine like new.





























